Is it safe to have a furnace in the attic?

Most forced-air heating systems are still poorly designed and installed. No! Don’t put your furnace in the attic! Furnaces should be installed in your basement or a mechanical room near the center of your house — not in a vented attic, vented crawl space, or garage.

Typically your furnace is centrally located in the home. It is usually located in an area such as a utility closet (by a cold air return), garage, attic, basement, or crawlspace; in the case of a heat-pump (a dual-system) it will be located outside of the home.

Also Know, how much does it cost to replace an attic furnace? The national average cost of a standard efficiency natural gas furnace ranges from $2,150 to $5,900 with most homeowners paying around $3,100.

Cost of a New Furnace.

Furnace Type Average Costs Cost per 100,000 BTU
Average Furnace Cost $2,150 – $5,900 $2.17

Also to know is, how does an attic furnace work?

A furnace in the attic supplies heat to the upper floors in a multi-level home. The ability to target and control heat to specific floors can save energy and make the climate more comfortable for inhabitants.

Do all houses have furnaces?

Heaters, Furnaces, And Boilers are all connected Most homes have a boiler and a furnace to some degree. The furnace is the primary source of central heat, pumping hot air into every room and kicking the cold to the wayside.

How do I reset my furnace?

How to Find My Furnace Motor Reset Button Turn off the power to the furnace at the circuit breaker. The circuit breaker is clearly marked. Lift up the blower compartment cover to access the blower wheel and blower motor. Look for a small red or yellow button on the side of the blower motor. Press the reset button down if it has popped up.

How hard is it to move a furnace?

As LordFrith said, the moving is the easy part. Wiring to the furnace, plumbing (gas or oil), and exhaust/chimney are going to be the hard parts. If you want to move it a few feet, that’s very likely doable. If you are talking across the room, it gets much more difficult.

Can you put a furnace in a closet?

Keep furnace components at least 12 inches from any combustible materials, such as insulation. Shield insulation with gypsum wallboard, which is flame-resistant, if it is necessary to put a furnace into a closet or wall cabinet. Provide a vent in any closet or cabinet door to permit free flow of air to the furnace.

How do I install a new furnace?

Furnace Installation: Step-by-Step Step 1: Choose your furnace and select the location for installation. Step 2: Decide where your duct and drain will run. Step 3: Connect to the ducting system. Step 4: Connect vent pipes. Step 5: Connect gas supply. Step 6: Connect electrical supply. Step 7: Connect condensate drain.

Where should HVAC returns be located?

Place your cold air return vents on the inside walls of buildings at the lowest point. The return vent pulls cold air from the bottom of the room and returns it to the furnace to be reheated and returned as warm air. Unlike supply vents, return vents do not need to be cased in metal.

Why would a house have 2 furnaces?

Additional Heat A second furnace allows you to add more heat into the home without overextending your existing furnace. A second furnace gives you added control over how warm you want your house to be, and makes your home more comfortable during times of extreme cold.

How many types of furnaces are there?

four

Does the furnace in the attic have a filter?

You either have filters in the ceiling intake vents or attached on the furnace in the attic, but not both. If you pulled them from your ceiling that’s all you need to do.

Can I convert my downflow furnace to upflow?

Re: Convert downflow to upflow You cannot change the fan mounting or flip it in any unit. Illegal in furnaces as the high temp limit controls won’t work and it won;t meet the UL and other codes or for insurance company reasons. Same if you have electric elements in a airhandler.

How much does it cost to move the furnace?

Gas Furnace Replacement Cost Estimator Gas Furnace Brand Estimated Furnace Cost Estimated Installed Cost Trane $1,350 $3,600 American Standard $1,450 $3,600 Lennox $1,500 $4,000 Average Cost* $1,500 $3,100

What part of HVAC is in attic?

Attic HVAC Systems Save Space Most updated central air conditioned homes have a new air conditioner split system, meaning the AC is broken up into parts: an outdoor unit, which houses the fan condenser and compressor, and an indoor unit, which holds the evaporator and fan.

Can I move my furnace and water heater?

You won’t want to move furnaces, hot water heaters and water filtration systems if you can help it, as this can get costly and create new problems.

How can I heat my attic?

How to Heat an Attic Seal any drafts from windows and doors. Install a mini split with a heat pump. Extend ductwork from central furnace up to attic. Install an electric fireplace that can be used when needed. Use a space heater to warm up the room when needed.